2 PIN CAP ASSEMBLY 6Y8-82582-01-00

2 PIN CAP ASSEMBLY

4 PIN CAP ASSEMBLY 6Y8-82582-11-00

Part #6Y8-82582-11-00

Superseded from Part # 6Y8-82582-10-00

GRAY MAIN BUS TERMINATOR RESISTOR CAP 6Y8-85371-01-00

GRAY MAIN BUS TERMINATOR RESISTOR CAP

NMEA 2000 "T" CONNECTOR 8M6004829

PART # 8M6004829

NMEA 2000 T CONNECTOR

FUEL TANK SENDER AND GPS LEAD 6Y8-8356N-01-00

Part #6Y8-8356N-01-00

Superseded from Part # 6Y8-8356N-00-00

6" NMEA 2000 AGI AND HELMASTER ADAPTOR 6Y9-83553-50-00

ADAPTOR, 6" NMEA 2000 AGI AND HELMASTER

IN-LINE HUB ASSEMBLY 6Y8-81920-11-00

Part #6Y8-81920-11-00

Superseded from Part # 6Y8-81920-10-00

WHITE COMMAND LINK PLUS DISPLAY COVER 6Y9-87278-00-00

Part # 6Y9-87278-00-00

3 PORT MULTI-HUB ASSEMBLY 6Y8-81920-01-00

3 PORT MULTI-HUB ASSEMBLY

8 FT POWER LEAD 6Y8-83553-01-00

8 FT POWER LEAD

GATEWAY NMEA 2000 LEAD WIRE 6YG-82521-00-00

Part # 6YG-82521-00-00

NMEA 2000 STARTER KIT 8M0110642

Part # 8M0114012

Kit includes:

• NMEA2000 power harness
• 1 male termination resistor
• 1 female termination resistor
• "T" connector

Whenever a NMEA2000 backbone is required, these are the basic components required to start that architecture.

3 PORT MULTI-HUB ASSEMBLY AND 6Y8-82553-01-00 1 FT MAIN BUS WIRE 6Y8-81920-01-00KIT

Part # 6Y8-81920-01-00KIT

Superseded from Part # 6Y8-81920-00-00

Includes: 1 each 6Y8-81920-01-00 3 PORT MULTI-HUB ASSEMBLY
1 each 6Y8-82553-01-00 1 FT. MAIN BUS WIRE

REMOTE VARIABLE TROLLING RPM SWITCH KIT (VTS)

Part # MAR-VTSSW-00-KT

With this new switch, increased VTS functionality is at your fingertips by adjusting the RPM without the gauge. The switch is compatible with F25C, F30 through F115 (2nd Generation Only - B Series) and VF115 (remote control models only). This helm-mounted remote switch connects to tiller handle input on the outboard. A brand new way to make fishing (and boating) easier at a low cost with huge benefits. The switch comes with a 26 foot harness length. Plugs into port directly on the engine.

RETURNED SPEED SENSOR KIT 60V-8A4L1-18-00RET

Part # 60V-8A4L1-18-00RET

Superseded from Part # 60V-8A4L1-17-00, 60V-8A4L1-16-00, 60V-8A4L1-14-00, 60V-8A4L1-13-00, 60V-8A4L1-12-00, 60V-8A4L1-11-00, 60V-8A4L1-10-00

SPEED SENSOR KIT 60V-8A4L1-1A-00

Part # 60V-8A4L1-1A-00

Superseded from Part # 60V-8A4L1-17-00, 60V-8A4L1-16-00, 60V-8A4L1-14-00, 60V-8A4L1-13-00, 60V-8A4L1-12-00, 60V-8A4L1-11-00, 60V-8A4L1-10-00, 60V-8A4L1-18-00

RETURNED LESS THAN PERFECT DEC ONLY KEY SWITCH PANEL SWITCH ASSEMBLY 6X6-82570-33-00LTP

SWITCH RETURNED WITH SOME MARKS IN THE BOTTOM OF THE FACEPLATE. WILL BE DIFFICULT TO SEE WHEN INSTALLED.

Part # 6X6-82570-33-00

For Single DEC engines only. Engines that are throttled and shifted by wire. Not mechanical throttle and shifted engines.

Superseded from Part # 6X6-82570-30-00,6X6-82570-31-00,6X6-82570-31-00 and 6X6-82570-32-00

DEC ONLY KEY SWITCH PANEL SWITCH ASSEMBLY 6X6-82570-33-00

Part # 6X6-82570-33-00

For Single DEC engines only. Engines that are throttled and shifted by wire. Not mechanical throttle and shifted engines.

Superseded from Part # 6X6-82570-30-00,6X6-82570-31-00,6X6-82570-31-00 and 6X6-82570-32-00

COMMAND LINK PLUS AND COMMAND LINK N2K GATEWAY 6YG-8A2D0-00-00

Part # 6YG-8A2D0-00-00

This Product REPLACES Part # 6Y9-8A2D0-40-00, MAR-GTWAY-ML-09 AND MAR-GTWAY-KT-00

Yamaha NMEA 2000 Gateway device. Works with both the Command Link Plus color display and Command Link square or round gauge systems. This part is for the gateway only and does not come with the pigtail buss wire that is needed. 1 FT (or longer) pigtail buss wire is required to connect the gateway to 3-port Command link hub. A open port on the Command link 3-port hub will be needed. If one is not available, another 3 port hub will need to be installed: 6Y8-81920-01-00KIT

COMMAND LINK PLUS AND COMMAND LINK N2K GATEWAY KIT WITH PIGTAIL WIRE (6Y8-82521-01-00) 6YG-8A2D0-00-00KIT

Part # 6YG-8A2D0-00-00

Includes pigtail wire 6Y8-82521-01-00. This Product REPLACES Part # 6Y9-8A2D0-40-00, MAR-GTWAY-ML-09 AND MAR-GTWAY-KT-00

Yamaha NMEA 2000 Gateway device. Works with both the Command Link Plus color display and Command Link square or round gauge systems. 1 FT (or longer) pigtail buss wire is required to connect the gateway to 3-port Command link hub. A open port on the Command link 3-port hub will be needed. If one is not available, another 3 port hub will need to be installed: 6Y8-81920-01-00KIT

TWIN ENGINE COMMAND LINK KEY SWITCH PANEL 6Y8-82570-04-00

Part # 6Y8-82570-04-00

Superseded from Part # 6Y8-82570-03-00, 6Y8-82570-02-00, 6Y8-82570-01-00, 6Y8-82570-00-00

COMMAND LINK PLUS AND COMMAND LINK N2K GATEWAY KIT WITH PIGTAIL WIRE AND N2K HARNESS MAR-GTWAY-KT-20

Part # MAR-GTWAY-KT-20

1 each 1 Ft Pigtail Buss Wire: 6Y8-82521-01-00
1 each Command Link Plus and Gateway: 6YG-8A2D0-00-00
1 each N2K Harness

This Product REPLACES Part # 6Y9-8A2D0-40-00, MAR-GTWAY-ML-09 AND MAR-GTWAY-KT-00, MAR-GTWAY-KT-10

Yamaha NMEA 2000 Gateway device. Works with both Command Link Plus color display, 6YC Display and Command Link square or round gauge systems. Kit Includes the 1 FT Pigtail buss wire required to connect the gateway to a 3-port Command link hub. A open port on the Command link 3-port hub will be needed. If one is not available, another 3 port hub will need to be installed: 6Y8-81920-01-00KIT